top of page

MASONRY SUPPORT

Engineered systems for the built environment

KBS product families are developed around practical design, engineering, manufacture and installation requirements, with technical support available throughout the project lifecycle.

KERNIX

Masonry support systems

Engineered stainless steel masonry support for brickwork and facade applications, supported by project-specific design, calculations, detailing and fixing selection.

Technical Resources

KB1 45.png

KERNIX KB1

Standard Masonry Support System

The KB1 is the standard Kernix welded bracket masonry support arrangement, with the support angle positioned in the conventional orientation beneath the brickwork. It is intended for typical cavity wall and façade applications where the support steel can be located directly below the masonry zone.


Why it is used: KB1 is the default solution for most standard masonry support conditions, offering a simple, efficient arrangement with straightforward load transfer back to the structural frame.

Brushed Metal Angled Support Bracket.png

KERNIX KB2

Reversed Angle Masonry Support System

The KB2 uses a reversed support-angle arrangement, allowing the horizontal leg and bracket geometry to be configured differently from the standard KB1 system. This provides greater flexibility where façade build-up, cavity depth, architectural detailing or site constraints prevent a conventional support angle arrangement.


Why it is used: KB2 is used where the geometry of the wall build-up requires the support steel to sit differently, helping resolve restricted spaces, unusual cavity conditions or interface requirements without changing the fundamental support principle.

KERNIX KB3

Inverted Masonry Support System

The KB3 is an inverted masonry support arrangement developed for applications where the bracket and support angle need to be positioned above or behind the normal support zone. The inverted configuration provides an alternative load path where the structural frame, slab edge or façade detail makes a standard or reversed arrangement unsuitable.


Why it is used: KB3 is typically selected for more complex façade interfaces, restricted slab-edge conditions or architectural details where support steel must be concealed, raised or positioned away from the conventional location.

KB1, KB2 and KB3 can be engineered to suit project-specific loads, cavity dimensions, structural fixing zones and façade geometry.

bottom of page